Applies to warm frame and hybrid construction.
Light steel infill walls.
In all cases aqua board is used as an external sheathing board but may also be used internally in bathrooms and other wet areas etc.
Metek offer a full range of external walling solutions manufactured from cold formed galvanised light steel members for usage infill and continuous external walls.
Types of infill panel walls.
Infill walls are designed on a project specific basis to form the inner leaf of an external façade.
The benefits of light steel infill walls are.
There are three generic types of light steel external wall systems.
The use of light steel framing in infill walls are illustrated in figures 0 4 and 0 5.
Infill walling is the generic name given to a panel that is built in between the floors of the primary structural frame of a building and provides support for the cladding system.
Light weight speed and ease of installation are important constructional benefits.
Modular construction is a special case.
Rapid installation allows other activities within the building to proceed much earlier than would be possible with block work infill walls.
Traditionally infill panel walls used brick masonry or timber.
Light steel infill walls use vertical c sections referred to as studs that span between the floors of the primary frame and around openings.
Applies to primary structural and secondary components including external infill lsf walls.
The construction process is dry so that shrinkage and other drying out problems are eliminated.
Light steel infill walls are used extensively on a range of building types and are an economic and efficient method of providing an external wall capable of resisting wind loads and supporting a range of cladding types.
The c section size and spacing selected depend on the structural requirements.
Light steel infill walls a g j way meng ceng mice technical information sheet ed013 infill walling is the generic name given to external walls that are built between the floors of the primary structural frame of a building and which provide support for the cladding system.
Infill walls do not support floor loads but they.
Light steel walls using c sections are increasingly.
The spacing is also selected to be compatible with the external façade.
However these are more time consuming than modern alternatives and have been largely replaced by lightweight steel c sections that span between floors and around openings.
All solutions are designed and engineered specifically to suit your project requirements by our in house technical team.
This chapter gives guidance on meeting the technical requirements for light steel framed lsf construction using 0 7 4 0mm thick framing members and.