If you encounter an obstruction stop the drill and remove it from the hole then insert a masonry nail with the tip touching the block.
Drill into vinyl fence.
Vinyl fencing is a relatively new maintenance free type of fencing.
Both rain and sunshine have a negative effect on traditional wooden fencing.
It s available in forms similar to both wood panel and rail fencing.
Vinyl fencing isn t subject to rot fading or other effects of weather and time as wood fencing can be.
1 16 of over 1 000 results for vinyl fence screws amazon s choice for vinyl fence screws the hillman groupthe hillman group 35242 pan head square drive sheet metal screw 10 x 3 4 60 pack white.
I have a vinyl plastic fence and i want to attach motion detector very light weight lights to the main posts.
It still needs decorating in my opinion as i was trying to figure out how to hang things from the fence without making holes i googled fence hangers.
This is a flat metal sheet with vinyl covering.
The pembroke vinyl fence will add value to your home for decades to come.
Attach the proper drill bit to the drill and line it up to the first mark on the siding.
Run the drill at a slow to medium speed and pull the drill out periodically to help remove concrete dust from the hole.
Vinyl fencing is the future in more ways than one.
Trim is normally applied over solid areas.
I have to stop and open the gate every trip in and out with hands full.
All sorts of things wear down wood fencing.
The trick here to avoid your screw wandering all over the metal trim is to use a nail set or even just a larger nail and tap a small pilot pit into the trim piece.
Place a fine tooth saw blade against the vinyl fence using the flat surface of the fence as a guide.
Saw down through the expanded foam insulation to trim it flush with the vinyl fence.
A big problem with a vinyl fence is that it is very white which is why we went with a grey insert along the back.
Right now i have a big rock i roll in front to hold it open but it s scratching my.
Turn on the drill and push down firmly to begin drilling through the vinyl and into the brick or plywood.
Also on the gate i d like to attach one of those drop down door stops so my gate will stay open when i m unloading groceries.
Another area is the vinyl trim found on beams and eaves.
Continue pushing until the brick or plywood has been penetrated and stop before going completely through the material.
Vinyl is a good choice for an attractive easily maintained fence system.